- Getting Started
- Administration Guide
-
User Guide
- An Introduction to Wyn Enterprise
- Document Portal for End Users
- Data Governance and Modeling
- Working with Resources
- Working with Reports
- Working with Dashboards
- View and Manage Documents
- Understanding Wyn Analytical Expressions
- Section 508 Compliance
- Subscribe to RSS Feed for Wyn Builds Site
- Developer Guide
Join Data
The Join Data command is used to join two data sources into a single dataset.
Configuration
After you add a Join Data ETL command to the ETL designer and connect two inputs to it, you need to choose the type of join to use. The supported join types are Inner, left, right, or full join. You also need to specify the join column(s) to join on from each input table.